Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
ip pim sparse-mode
Enable PIM sparse mode and IGMP on the interface.
Syntax
ip pim sparse-mode
To disable PIM sparse mode and IGMP, use the
no ip pim sparse-mode
command.
Defaults
Disabled.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The interface must be enabled (the
no shutdown
command) and not have the
switchport
command configured. Multicast must also be enabled globally (using
the
ip multicast-lag-hashing
command). PIM is supported on the port-
channel interface.
ip pim sparse-mode sg-expiry-timer
Enable expiry timers globally for all sources, or for a specific set of (S,G) pairs an access list defines.
Syntax
ip pim sparse-mode sg-expiry-timer
seconds
[access-list name]
To disable configured timers and return to default mode, use the
no ip pim
sparse-mode sg-expiry-timer
command.
Parameters
seconds
Enter the number of seconds the S, G entries are retained.
The range is from 211 to 86400.
access-list
name
(OPTIONAL) Enter the name of a previously configured
Extended ACL to enable the expiry time to specified S,G
entries.
Defaults
Disabled. The default expiry timer (with no times configured) is 210 sec.
PIM-Sparse Mode (PIM-SM)
1021