Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the
show ip pim snooping neighbor
commands
shown in the following example.
Field
Description
Neighbor address
Displays the IP address of the neighbor learned through
PIM-SM snooping.
Interface
Displays the VLAN ID number and slot/port on which the
PIM-SM-enabled neighbor was discovered.
Uptime/expires
Displays the amount of time the neighbor has been up then
the amount of time until the neighbor is removed from the
multicast routing table (that is, until the neighbor hold time
expires).
Ver
Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode
Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the
ip pim
dr-priority
command)
• DR = Designated Router
• S = Sparse mode
Example
Dell#show ip pim snooping neighbor
Neighbor Interface Uptime/Expires Ver DR Prio
Address
165.87.32.2 Vl 2 [Gi 4/13 ] 00:04:03/00:01:42 v2 1
165.87.32.10 Vl 2 [Gi 4/11 ] 00:00:46/00:01:29 v2 0
165.87.32.12 Vl 2 [Gi 4/20 ] 00:00:51/00:01:24 v2 0
show ip pim snooping tib
Display information from the tree information base (TIB) PIM-SM snooping discovered about multicast
group members and states.
Syntax
show ip pim snooping tib [vlan
vlan-id
] [
group-address
[
source-
address
]]
Parameters
vlan
vlan-id
(OPTIONAL) Enter a VLAN ID to display TIB information PIM-
SM snooping discovered on a specified VLAN. The valid
VLAN IDs range is from 1 to 4094.
1028
PIM-Sparse Mode (PIM-SM)