Defaults
Refer to Parameters.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority
priority-value
To remove the DR priority value assigned, use the
no ipv6 pim dr-priority
command.
Parameters
priority-value
Enter a number. Preference is given to larger/higher number.
The range is from 0 to 4294967294. The default is
1
.
Defaults
1
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The router with the largest value assigned to an interface becomes the designated
router. If two interfaces contain the same designated router priority value, the
interface with the largest interface IP address becomes the designated router.
ipv6 pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the
PIM-SM router from creating state based on multicast source and/or group.
Syntax
ipv6 pim join-filter
access-list
Parameters
access-list
Enter the name of an extended access list.
in
Enter the keyword
in
to apply the access list to inbound
traffic.
out
Enter the keyword
out
to apply the access list to outbound
traffic.
PIM-Sparse Mode (PIM-SM)
1035