Use this command to match an IP class-map against a single VRF ID .
Related
Commands
class-map
— identifies the class map.
description
Add a description to the selected policy map or QoS policy.
Syntax
description {
description
}
To remove the description, use the
no description {
description
}
command.
Parameters
description
Enter a description to identify the policies (80 characters
maximum).
Defaults
none
Command
Modes
CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in
and conf-qos-policy-out; wred)
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
policy-map-output
— creates an output policy map.
qos-policy-output
— creates an output QoS-policy on the router.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
Syntax
match {ip | ipv6 | ip-any} dscp
dscp-list
[set-ip-dscp
value
]
To remove a DSCP value as a match criteria, use the
no match {ip | ipv6 |
ip-any} dscp
dscp-list
[[multicast] set-ip-dscp
value
]
command.
Parameters
ip
Enter the keyword
ip
to support IPv4 traffic.
ipv6
Enter the keyword
ipv6
to support IPv6 traffic
ip-any
Enter the keyword
ip-any
to support IPv4 and IPv6 traffic.
1084
Quality of Service (QoS)
