Usage
Information
RIP supports a maximum of 16 ECMP paths.
neighbor
Define a neighbor router with which to exchange RIP information.
Syntax
neighbor
ip-address
To delete a neighbor setting, use the
no neighbor
ip-address
command.
Parameters
ip-address
Enter the IP address, in dotted decimal format, of a router
with which to exchange information.
Defaults
Not configured.
Command
Modes
ROUTER RIP
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple
neighbor routers are possible.
To ensure that only specific interfaces are receiving and sending data, use the
passive-interface
command with the
neighbor
command.
Related
Commands
passive-interface
— sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this
command.
Syntax
network
ip-address
To disable RIP for a network, use the
no network
ip-address
command.
Parameters
ip-address
Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
Defaults
No RIP network is configured.
Routing Information Protocol (RIP)
1121
