Command
Modes
ROUTER RIP
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the
network
command
specifies.
offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
Syntax
offset-list
prefix-list-name
{in | out}
offset
[
interface
]
To delete an offset list, use the
no offset-list
prefix-list-name
{in |
out}
offset
[
interface
]
command.
Parameters
prefix-list-
name
Enter the name of an established Prefix list to determine
which incoming routes are modified.
offset
Enter a number from zero (0) to 16 to be applied to the
incoming route metric matching the access list specified. If
you set an offset value to zero (0), no action is taken.
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then a number from
1 to 4094.
Defaults
Not configured.
Command
Modes
ROUTER RIP
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When the offset metric is applied to an interface, that value takes precedence over
an offset value that is not extended to an interface.
1122
Routing Information Protocol (RIP)
