• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
in | out | both
Enter the keyword
in
,
out
, or
both
to debug incoming
interfaces, outgoing interfaces, or both incoming and
outgoing interfaces.
vlan
vlan-id
Enter the keyword
vlan
then the VLAN ID. The range is from
1 to 4094.
count
value
Enter the keyword
count
then the number of debug
outputs. The range is from 1 to 100.
Defaults
Debug disabled.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
protocol-tunnel
Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
Syntax
protocol-tunnel {rate-limit
rate
| stp}
To disable protocol tunneling for a Layer 2 protocol, use the
no protocol-
tunnel
command.
Parameters
rate-limit
rate
Enter the keyword
rate-limit
then a number for the rate-
limit for tunneled packets on the VMAN. The range is from
64 to 320.
stp
Enter the keyword
stp
to enable protocol tunneling on a
spanning tree, including STP, MSTP, RSTP, and PVST.
Defaults
none
Command
Modes
CONF-IF-VLAN
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#conf
Dell(conf)#interface vlan 2
Dell(conf-if-vl-2)#vlan-stack compatible
Dell(conf-if-vl-2)#member Gi1/2-3
Dell(conf-if-vl-2)#protocol-tunnel stp
Dell(conf-if-vl-2)#protocol-tunnel enable
Service Provider Bridging
1217