Defaults
As above.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Changing the value of the SNMP Engine ID has important side effects. A user’s
password (entered on the command line) is converted to a message digest
algorithm (MD5) or secure hash algorithm (SHA) security digest. This digest is based
on both the password and the local Engine ID. The command line password is then
destroyed, as required by RFC 2274. Because of this deletion, if the local value of
the Engine ID changes, the security digests of SNMPv3 users is invalid and you
must reconfigure the users.
For the remote Engine ID, the host IP and UDP port are the indexes to the
command that are matched to either overwrite or remove the configuration.
Related
Commands
show snmp engineID
— displays the SNMP engine and all the remote engines that
are configured on the router.
show running-config
— displays the SNMP running configuration.
snmp-server group
Configure a new SNMP group or a table that maps SNMP users to SNMP views.
Syntax
snmp-server group [
group_name
{1 | 2c | 3 {auth | noauth |
priv}}] [read
name
] [write
name
] [notify
name
] [
access-list-
name
|
access-list-name
]]
To remove a specified group, use the
no snmp-server group [
group_name
{v1 | v2c | v3 {auth | noauth | priv}}] [read
name
] [write
name
] [notify
name
] [
access-list-name
|
access-list-name
]]
command.
Parameters
group_name
Enter a text string (up to 20 characters long) as the name of
the group. The following groups are created for mapping to
read/write community/security-names (defaults):
•
v1v2creadg
— maps to a community/security-name
with
ro
permissions.
•
1v2cwriteg
— maps to a community/security-name
rw
permissions.
1 | 2c | 3
(OPTIONAL) Enter the security model version number (
1
,
2c
,
or
3
):
Simple Network Management Protocol (SNMP) and Syslog
1229