snmp-server enable
command and the
snmp-server host
command for that
host must be enabled.
NOTE: For v1 / v2c trap configuration, if the community-string is not defined
using the
snmp-server community
command prior to using this command,
the default form of the
snmp-server community
command automatically is
configured with the community-name the same as specified in the
snmp-
server host
command.
Configuring Informs
To send an inform, use the following steps:
1.
Configure a remote engine ID.
2.
Configure a remote user.
3.
Configure a group for this user with access rights.
4.
Enable traps.
5.
Configure a host to receive informs.
Related
Commands
snmp-server enable traps
— enables SNMP traps.
snmp-server community
— configures a new community SNMPv1 or SNMPv2c.
snmp-server location
Configure the location of the SNMP server.
Syntax
snmp-server location
text
To delete the SNMP location, use the
no snmp-server location
command.
Parameters
text
Enter an alpha-numeric text string, up to 55 characters long.
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Simple Network Management Protocol (SNMP) and Syslog
1233