tunnel flow-label
Configure the method to set the IPv6 flow label value in the outer tunnel header.
Syntax
tunnel flow-label
value
To return to the default value of 0, use the
no tunnel flow-label
value
command.
Parameters
value
Enter a value to set the IPv6 flow label value in the tunnel
header. The range is from 0 to 1048575. The default value is
0
.
Defaults
0
(Mapped original packet flow-label value to tunnel header flow-label value)
Command
Modes
INTERFACE TUNNEL (conf-if-tu)
Command
History
Version 9.3(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command is only valid for tunnel interfaces with an IPv6 outer header.
tunnel hop-limit
Configure the method to set the IPv4 time-to-live or the IPv6 hop limit value in the outer tunnel header.
Syntax
tunnel hop-limit
value
To restore the default tunnel hop-limit, use the
no tunnel hop-limit
command.
Parameters
value
Enter the hop limit (ipv6) or time-to-live (ipv4) value to
include in the tunnel header. The range is from 0 to 255. The
default is
64
.
Defaults
64
(Time-to-live for IPv4 outer tunnel header or hop limit for IPv6 outer tunnel
header)
Command
Modes
INTERFACE TUNNEL (conf-if-tu)
Command
History
Version 9.3(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Tunneling
1301