Example
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active M Gi 13/13
M Gi 13/0-2
3 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/3
4 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/4
5 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/5
Dell#
vlan-stack dot1p-mapping
Map C-Tag dot1p values to a S-Tag dot1p value. You can separate the C-Tag values by commas and
dashed ranges are permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration in case of
conflicts.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p
values
sp-tag-dot1p
value
Parameters
c-tag-dot1p
value
Enter the keyword
c-tag-dot1p
then the customer dot1p
value that is mapped to a service provider do1p value. The
range is from 0 to 5.
sp-tag-dot1p
value
Enter the keyword
sp-tag-dot1p
then the service provider
dot1p value. The range is from 0 to 5.
Defaults
none
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
vlan-stack protocol-type
Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN
tag). If you do not configure this command, the system assigns the value 0x9100.
Syntax
vlan-stack protocol-type
number
VLAN Stacking
1327