Parameters
number
Enter the hexadecimal number as the stackable VLAN tag.
You may specify both bytes of the 2-byte S-Tag TPID. The
range is from 0 to FFFF. The default is
9100
.
Defaults
0x9100
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
For specific interoperability limitations regarding the S-Tag TPID, refer to the
Dell
Networking OS Configuration Guide
.
Related
Commands
portmode hybrid
— sets a port (physical ports only) to accept both tagged and
untagged frames. A port configured this way is identified as a hybrid port in report
displays.
vlan-stack trunk
— specifies a Layer 2 port or port channel as a trunk port to the
Stackable VLAN network.
vlan-stack trunk
Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network.
Syntax
vlan-stack trunk
To remove a trunk port designation from the selected interface, use the
no vlan-
stack trunk
command.
Defaults
Not configured.
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Prior to using this command, to place the interface in Layer 2 mode, execute the
switchport
command.
To remove the trunk port designation, first remove the port (using the
no member
interface
command) from all stackable VLAN-enabled VLANs.
Starting with the Dell Networking OS version 7.8.1.0, a VLAN-Stack trunk port is
also allowed to be configured as a tagged port and as an untagged port for single-
1328
VLAN Stacking