show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the system returns
No Active VRRP
group
.
Syntax
show vrrp [
vrrp-id
] [
interface
] [brief]
Parameters
vrrp-id
(OPTIONAL) Enter the Virtual Router Identifier for the VRRP
group to view only that group. The range is from 1 to 255.
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For Port Channel interface types, enter the keywords
port-channel
then the number. The range is from 1 to
128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a VLAN interface, enter the keyword
vlan
then the
VLAN ID. The VLAN ID range is from 1 to 4094.
brief
(OPTIONAL) Enter the keyword
brief
to view a table of
information on the VRRP groups.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the
show vrrp brief
command shown in the following
example.
Item
Description
Interface
Lists the interface type, slot and port on which the VRRP
group is configured.
Grp
Displays the VRRP group ID.
Pri
Displays the priority value assigned to the interface. If the
track
command is configured to track that interface and
the interface is disabled, the cost is subtracted from the
priority value assigned to the interface.
Pre
States whether preempt is enabled on the interface.
•
Y
= Preempt is enabled.
•
N
= Preempt is not enabled.
State
Displays the operational state of the interface by using one
of the following:
Virtual Router Redundancy Protocol (VRRP)
1351
