Usage
Information
A DCB map is a template used to configure DCB parameters and apply them on
converged Ethernet interfaces. DCB parameters include priority-based flow control
(PFC) and enhanced traffic selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the
show qos dcb-map
command.
Use the
dcb-map
command to create a DCB map to specify PFC and ETS settings
and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC
and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is
enabled on Ethernet ports by default.
The
dcb-map
command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the
no dcb-map
map-name
command in Interface configuration mode.
Related
Commands
show qos dcb-map
– displays the dcb-map profiles configured on the system.
priority-pgid
Assign 802.1p priority traffic to a priority group in a DCB map.
FC Flex IO Modules with MXL
Syntax
priority-pgid
dot1p0_group-num
dot1p1_group-num
dot1p2_group-
num
dot1p3_group-num
dot1p4_group-num
dot1p5_group-num
dot1p6_group-num
dot1p7_group-num
Parameters
dot1p0_group-
num
Enter the priority group number for each 802.1p class of
traffic in a DCB map.
dot1p1_group-
num
dot1p2_group-
num
dot1p3_group-
num
dot1p4_group-
num
dot1p5_group-
num
dot1p6_group-
num
dot1p7_group-
num
1372
FC Flex IO Modules