sum of configured bandwidth allocation to dot1p priority traffic in all ETS priority
groups must be 100%. Allocate at least 1% of the total bandwidth to each priority
group and queue. If bandwidth is assigned to some priority groups but not to
others, the remaining bandwidth (100% minus assigned bandwidth amount) is
equally distributed to nonstrict-priority groups which have no configured
scheduler.
Related
Commands
•
qos-policy-output ets
— creates a QoS output policy.
•
scheduler
— schedules priority traffic in port queues.
clear ets counters
Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port
Parameters
port-type
Enter the keywords
port-type
then the slot/port
information.
Defaults
none
Command
Modes
EXEC Privilege
Command
History
Version 9.3(0.0)
Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
Syntax
dcb-map
map-name
Parameters
map-name
Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Defaults
None.
Command
Modes
CONFIGURATION
INTERFACE
Command
History
Version 9.3(0.0)
Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
1386
FC Flex IO Modules
