Usage
Information
To disable TLV transmission, use the
no
form of the command; for example,
no
advertise dcbx-appln-tlv iscsi
.
advertise dcbx-tlv
On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-
reco | pfc] [ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the
no advertise dcbx-tlv
command.
Parameters
{ets-conf | ets-
reco | pfc}
Enter the PFC and ETS TLVs advertised, where:
•
ets-conf:
enables the advertisement of ETS
configuration TLVs.
•
ets-reco:
enables the advertisement of ETS
recommend TLVs.
•
pfc:
enables the advertisement of PFC TLVs.
Defaults
All PFC and ETS TLVs are advertised.
Command
Modes
PROTOCOL LLDP
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure the transmission of more than one TLV type at a time; for
example:
advertise dcbx-tlv ets-conf ets-reco
.
You can enable ETS recommend TLVs (
ets-reco
) only if you enable ETS
configuration TLVs (
ets-conf
). To disable TLV transmission, use the
no
form of
the command; for example,
no advertise dcbx-tlv pfc ets-reco
.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the
show interface
dcbx detail
command.
bandwidth-percentage
Configure the bandwidth percentage allocated to priority traffic in port queues.
Syntax
bandwidth-percentage
percentage
To remove the configured bandwidth percentage, use the
no bandwidth-
percentage
command.
1422
PMUX Mode of the MXL 10/40GbE Switch I/O Module
