dscp
dscp-
value
Enter the DSCP value assigned to the incoming packets in an
iSCSI session. The valid range is from 0 to 63. The default is:
the DSCP value in ingress packets is not changed.
remark
Marks the incoming iSCSI packets with the configured dot1p
or DSCP value when they egress to the switch. The default is:
the dot1and DSCP values in egress packets are not changed.
Defaults
The default dot1p VLAN priority value is 4 without the
remark
option.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
iscsi enable
Globally enable iSCSI optimization.
Syntax
iscsi
enable
To disable iSCSI optimization, use the
no iscsi enable
command.
Parameters
enable
Enter the keyword
enable
to enable the iSCSI optimization
feature.
Defaults
Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable the iSCSI feature using the
iscsi enable
command, flow
control settings are set to
rx on tx off
on all interfaces.
iscsi priority-bits
Configure the priority bitmap that advertises in the iSCSI application TLVs.
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the
no iscsi priority-bits
command.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1461