On 4–port 10G stack units:
Changes in the flow-control values may not be
reflected automatically in the
show interface
output for 10G interfaces. This is
because 10G interfaces do not support auto-negotiation.
Important Points to Remember
• Do not enable
tx pause
when buffer carving is enabled. For information and
assistance, consult Dell Networking TAC.
• Asymmetric flow control (
rx on tx off
, or
rx off tx on
) setting for the
interface port less than 100 Mb/s speed is not permitted. The following error is
returned:
Can’t configure Asymmetric flowcontrol when speed <1G,
config ignored
• The only configuration applicable to half duplex ports is
rx off tx off
. The
following error is returned:
Cannot configure Asymmetric flowcontrol when speed <1G,
config ignored>
• You cannot configure half duplex when the flow control configuration is on
(default is
rx on tx on
). The following error is returned:
Cannot configure
half duplex when flowcontrol is on, config ignored
NOTE: The flow control must be off (
rx off tx off
) before configuring the
half duplex.
Example
(partial)
Dell(conf-if-tengig-0/1)#show config
!
interface TenGigabitEthernet 0/1
no ip address
switchport
no negotiation auto
flowcontrol rx off tx on
no shutdown
...
Example
(Values)
This Example shows how the Dell Networking OS negotiates the flow control
values between two Dell Networking chassis connected back-to-back using 1G
copper ports.
Configured
LocRxConf LocTxConf RemoteRxConf RemoteTxConf
off off off off
off on
on off
on on
off on off off
off on
on off
on on
on off off off
off on
on off
on on
on on off off
1466
PMUX Mode of the MXL 10/40GbE Switch I/O Module
