Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (
shutdown
) and are in Layer 3 mode. To
place an interface in mode, ensure that the interface’s configuration does not
contain an IP address and enter the
Port Channel Commands
command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.
Example
Dell(conf)#interface tengig 0/0
Dell(conf-if-tengig-0/0)#exit#
Related
Commands
interface port-channel
— configures a port channel.
interface vlan
— configures a VLAN.
show interfaces
— displays the interface configuration.
interface ManagementEthernet
Configure the Management port on the system.
Syntax
interface ManagementEthernet
slot/port
Parameters
slot/port
Enter the keyword
ManagementEthernet
, then the slot
number (0 or 1) and port number zero (0).
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (
no shutdown
). To assign an IP
address to the Management port, use the
ip address
command.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
1468
PMUX Mode of the MXL 10/40GbE Switch I/O Module