Defaults
none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
For details about using this command, refer to the “NIC Teaming” section of the
Layer 2 chapter in the
Dell Networking OS Configuration Guide
.
Link Aggregation Control Protocol (LACP)
This chapter contains commands for Dell Networks’s implementation of the link aggregation control
protocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as port-channels in the
Dell Networking Operating System (OS).
NOTE: For static LAG commands, refer to the
Interfaces
chapter), based on the standards specified
in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access method
and physical layer specifications.
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the
no lacp long-
timeout
command.
Defaults
1 second
Command
Modes
INTERFACE (conf-if-po-number)
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command applies to dynamic port-channel interfaces only. When applied on a
static port-channel, this command has no effect.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1493
