hello
Configure the rate at which the LLDP control packets are sent to its peer.
Syntax
hello
seconds
To revert to the default, use the
no hello
seconds
command.
Parameters
seconds
Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is from 5 to 180 seconds. The
default is
30 seconds
.
Defaults
30 seconds
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
interface
-lldp)
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
Syntax
multiplier
integer
To return to the default, use the
no multiplier
integer
command.
Parameters
integer
Enter the number of consecutive misses before the LLDP
declares the interface dead. The range is from 2 to 10.
Defaults
4 x hello
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
interface
-lldp)
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
1500
PMUX Mode of the MXL 10/40GbE Switch I/O Module