Defaults
none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.4.2.3
Introduced on the S-Series S50.
Usage
Information
After you enter the command, to assign upstream and downstream interfaces to
the group, enter Uplink-State-Group Configuration mode.
An uplink-state group is considered to be operationally up if at least one upstream
interface in the group is in the Link-Up state.
An uplink-state group is considered to be operationally down if no upstream
interfaces in the group are in the Link-Up state. No uplink-state tracking is
performed when a group is disabled or in an operationally down state.
To disable upstream-link tracking without deleting the uplink-state group, use the
no enable
command in uplink-state-group configuration mode.
Example
Dell(conf)#uplink-state-group 16
Dell(conf)#
02:23:17: %RPM0-P:CP %IFMGR-5-ASTATE_UP: Changed uplink state
group Admin state to up: Group 16
Related
Commands
•
show running-config uplink-state-group
— displays the current configuration
of one or more uplink-state groups.
•
show uplink-state-group
— displays the status information on a specified
uplink-state group or all groups.
upstream
Assign a port or port-channel to the uplink-state group as an upstream interface.
Syntax
upstream
interface
To delete an uplink-state group, use the
no upstream interface
command.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1529
