order
(OPTIONAL) Enter the keyword
order
to specify the QoS
order for the ACL entry. The range is from 0 to 254 (where 0
is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword
order
, the ACLs have the lowest order by default
(
255
).
fragments
Enter the keyword
fragments
to use ACLs to control packet
fragments.
log
(OPTIONAL) Enter the keyword
log
to enable the triggering
of ACL log messages.
threshold-in
msgs
count
(OPTIONAL) Enter the
threshold-in-msgs
keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the
seq
,
permit
, or
deny
commands. The threshold range is from 1 to 100.
interval
minutes
(OPTIONAL) Enter the keyword
interval
then by the time
period in minutes at which the ACL logs must be generated.
The interval range is from 1 to 10 minutes.
monitor
(OPTIONAL) Enter the keyword
monitor
when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Command
Modes
CONFIGURATION-IP ACCESS-LIST-STANDARD
Command
History
Version 9.4(0.0)
Added support for flow-based monitoring on the MXL
10/40GbE Switch IO Module platform.
Version 9.3(0.0)
Added support for logging of ACLs on the MXL 10/40GbE
Switch IO Module platform.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The
order
option is relevant in the context of the Policy QoS feature only. The
following applies:
• The
seq
sequence-number
command is applicable only in an ACL group.
• The
order
option works across ACL groups that have been applied on an
interface via the QoS policy framework.
• The
order
option takes precedence over
seq
sequence-number
.
• If
sequence-number
is not configured, the rules with the same order value are
ordered according to their configuration order.
Access Control Lists (ACL)
153