•
isis
— Enable ISIS adjacency change traps
•
pfc
— Enable pfc traps
•
snmp
— Enable SNMP trap
•
stp
— Enable 802.1d state change traps
•
vlt
— Enable VLT traps
•
vrrp
— Enable VRRP state change traps
•
xstp
— Enable 802.1s, 802.1w, and PVST+ state change
traps
The default is all trap types are sent to host.
Defaults
As above.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.1(0.0)
Added support for config and ecmp traps.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 8.4.1.0
Added support for VRRP traps.
Version 7.6.1.0
Added support for STP and xSTP notification types.
Introduced on the S-Series.
Version 7.5.1.0
Introduced on the C-Series.
E-Series legacy
command
Usage
Information
In order to configure the router to send SNMP notifications, enter at least
one
snmp-server host
command. If you enter the command with no keywords, all
trap types are enabled for the host. If you do not enter an
snmp-server host
command, no notifications are sent.
In order to enable multiple hosts, issue a separate
snmp-server host
command
for each host. You can specify multiple notification types in the command for each
host.
When multiple
snmp-server host
commands are given for the same host and
type of notification (trap or inform), each succeeding command overwrites the
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1535