Version 8.4.1.0
Added support for IPv6.
Version 7.6.1.0
Introduced on the S-Series.
Version 7.5.1.0
Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Multiple logging servers of both IPv4 and/or IPv6 can be configured.
Related
Commands
logging trap
— enables logging to the Syslog server based on severity.
logging buffered
Enable logging and specify which messages are logged to an internal buffer. By default, all messages are
logged to the internal buffer.
Syntax
logging buffered [
level
] [
size
]
To return to the default values, use the
default logging buffered
command.
To disable logging stored to an internal buffer, use the
no logging buffered
command.
Parameters
level
(OPTIONAL) Indicate a value from 0 to 7 or enter one of the
following equivalent words:
emergencies
,
alerts
,
critical
,
errors
,
warnings
,
notifications
,
informational
, or
debugging
. The default is
7
or
debugging
.
size
(OPTIONAL) Indicate the size, in bytes, of the logging buffer.
The number of messages buffered depends on the size of
each message. The range is from 40960 to 524288. The
default is
40960 bytes
.
Defaults
level =
7
; size =
40960 bytes
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0
Introduced on the S6000.
1538
PMUX Mode of the MXL 10/40GbE Switch I/O Module
