Command
History
Version 9.3(0.0)
Introduced on the MXL platform.
Usage
Information
The VLAN ContentAware Processor (VCAP) application is a pre-ingress CAP that
modifies the VLAN settings before packets are forwarded. To support the ACL CAM
optimization functionality, the CAM carving feature is enhanced. A total of four
VACP groups are present, of which two are for fixed groups and the other two are
for dynamic groups. Out of the total of two dynamic groups, you can allocate zero,
one, or two flow processor (FP) blocks to iSCSI Counters, OpenFlow and ACL
Optimization. You can configure only two of these features at a point in time.
show cam-usage
View the amount of CAM space available, used, and remaining in each partition (including IPv4Flow and
Layer 2 ACL sub-partitions).
Syntax
show cam-usage [acl | router | switch]
Parameters
acl
(OPTIONAL) Enter the keyword
acl
to display Layer 2 and
Layer 3 ACL CAM usage.
router
(OPTIONAL) Enter the keyword
router
to display Layer 3
CAM usage.
switch
(OPTIONAL) Enter the keyword
switch
to display Layer 2
CAM usage.
Command
Modes
EXEC
EXEC Privilege
Command
History
Version 9.3(0.0)
Introduced on the MXL 10/40GbE Switch IO Module
platform.
Usage
Information
The following regions must be provided in the
show cam-usage
output:
• L3AclCam
• L2AclCam
• V6AclCam
The following table describes the output fields of this
show
command:
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)
291