The default format for displaying the cluster-id is dotted decimal, but if you enter
the cluster-id as an integer, it is displayed as an integer.
Related
Commands
bgp client-to-client reflection
— enables route reflection between the route
reflector and clients.
neighbor route-reflector-client
— configures a route reflector and clients.
show ip bgp cluster-list
— views paths with a cluster ID.
bgp confederation identifier
Configure an identifier for a BGP confederation.
Syntax
bgp confederation identifier
as-number
To delete a BGP confederation identifier, use the
no bgp confederation
identifier as-number
command.
Parameters
as-number
Enter the AS number. The range is from 0 to 65535 (2 byte),
from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535
(dotted format).
Defaults
Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To accept 4-byte formats before entering a 4-byte AS number, configure your
system. All the routers in the Confederation must be 4 byte or 2 byte identified
routers. You cannot mix them.
The autonomous systems configured in this command are visible to the EBGP
neighbors. Each autonomous system is fully meshed and contains a few
connections to other autonomous systems. The next hop, MED, and local
preference information is preserved throughout the confederation.
The system accepts confederation EBGP peers without a LOCAL_PREF attribute.
The software sends AS_CONFED_SET and accepts AS_CONFED_SET and
AS_CONF_SEQ.
Related
Commands
bgp four-octet-as-support
— enables 4-byte support for the BGP process.
318
Border Gateway Protocol IPv4 (BGPv4)