Parameters
half-life
(OPTIONAL) Enter the number of minutes after which the
Penalty is decreased. After the router assigns a Penalty of
1024 to a route, the Penalty is decreased by half after the
half-life period expires. The range is from 1 to 45. The default
is
15 minutes
.
reuse
(OPTIONAL) Enter a number as the reuse value, which is
compared to the flapping route’s Penalty value. If the Penalty
value is less than the reuse value, the flapping route is once
again advertised (or no longer suppressed). The range is from
1 to 20000. The default is
750
.
suppress
(OPTIONAL) Enter a number as the suppress value, which is
compared to the flapping route’s Penalty value. If the Penalty
value is greater than the suppress value, the flapping route is
no longer advertised (that is, it is suppressed). The range is
from 1 to 20000. The default is
2000
.
max-suppress-
time
(OPTIONAL) Enter the maximum number of minutes a route
can be suppressed. The default is four times the half-life
value. The range is from 1 to 255. The default is
60 minutes
.
route-map
map-name
(OPTIONAL) Enter the keyword
route-map
then the name
of a configured route map.
Only
match
commands in the configured route map are
supported.
Defaults
Disabled.
Command
Modes
• ROUTER BGP
• ROUTER BGP-address-family
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you enter the
bgp dampening
command, the default values for
half-life
,
reuse
,
suppress
, and
max-suppress-time
are applied. The parameters are
position-dependent; therefore, if you configure one parameter, configure the
parameters in the order they appear in the CLI.
Related
Commands
show ip bgp dampened-paths
— views the BGP paths.
320
Border Gateway Protocol IPv4 (BGPv4)
