peer-group-
name
Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is
deny
(to
drop all routes).
in
Enter the keyword
in
to filter inbound routes.
out
Enter the keyword
out
to filter outbound routes.
Defaults
Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
neighbor route-reflector-client
Configure the router as a route reflector and the specified neighbors as members of the cluster.
Syntax
neighbor {
ip-address
|
peer-group-name
} route-reflector-client
To remove one or more neighbors from a cluster, use the
no neighbor {
ip-
address
|
peer-group-name
} route-reflector-client
command. If you
delete all members of a cluster, you also delete the route-reflector configuration
on the router.
Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
All routers in the peer group receive routes from a route
reflector.
Defaults
Not configured.
352
Border Gateway Protocol IPv4 (BGPv4)