Usage
Information
In the system best path selection process, the path with the highest weight value is
preferred.
NOTE: In the system best-path selection process, the path with the highest
weight value is preferred.
If you configure the
set weight
command in a route map applied to this
neighbor, the weight set in that command overrides the weight set in the
neighbor weight
command.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network
ip-address mask
[route-map
map-name
]
To remove a network, use the
no network
ip-address mask
[route-map
map-name
]
command.
Parameters
ip-address
Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
route-map
map-name
(OPTIONAL) Enter the keyword
route-map
then the name
of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
•
match ip address
•
set metric
•
set tag
If the route map is not configured, the default is
deny
(to
drop all routes).
Defaults
Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Border Gateway Protocol IPv4 (BGPv4)
357