NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the
dcb-map
commands in the future.
Related
Commands
dcb-policy input
— applies the input policy with the PFC configuration.
dcb-output
To associate an ETS configuration with priority traffic, create a DCB output policy.
Syntax
dcb-output
policy-name
To remove the ETS output policy globally, use the
no dcb output
policy-name
command.
Parameters
policy-name
Enter the DCB output policy name. The maximum is 32
alphanumeric characters.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To associate a priority group with an ETS output policy with scheduling and
bandwidth configuration, create a DCB output policy. You can apply a DCB output
policy on multiple egress ports. When you apply an ETS output policy on an
interface, ETS-configured scheduling and bandwidth allocation take precedence
over any configured settings in QoS output policies.
The ETS configuration associated with 802.1 priority traffic in a DCB output policy
is used in DCBX negotiation with ETS peers.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the
dcb-map
commands in the future.
Related
Commands
dcb-policy output
— applies the output policy.
418
Data Center Bridging (DCB)