Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
On the MXL switch, after you enter the
clear counters
command and verify the
results with the
show interfaces
command, the line rate is not reset to 0.00%.
Example
Dell#clear dampening gigabitethernet 1/2
Clear dampening counters on tengig 1/2 [confirm] y
Dell#
Related
Commands
show interfaces dampening
— displays interface dampening information.
dampening
— configures dampening on an interface.
cx4-cable-length
Configure the length of the cable to be connected to the selected CX4 port.
Syntax
[no] cx4-cable-length {long | medium | short}
Parameters
long | medium |
short
Enter the keyword that matches the cable length to be used
at the selected port:
•
short
= For 1-meter and 3-meter cable lengths.
•
medium
= For 5-meter cable length.
•
long
= For 10-meter and 15-meter cable lengths.
Defaults
medium
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command only works on ports that the system recognizes as CX4 ports. The
figures below shows an attempt to configure an XFP port with the command after
inserting a CX4 converter into the port.
Interfaces
555