Usage
Information
This command applies to any physical interface with speed set to 1000/10000.
NOTE: Starting with the Dell Networking OS version 7.8.1.0, when you use a
copper SFP2 module with catalog number GP-SFP2-1T in the S25P module,
you can manually set its speed with the
speed
command. When you set the
speed to 10 Mbps or 100 Mbps, you can also execute the
duplex
command.
Related
Commands
speed (for 1000/10000/auto interfaces)
— sets the speed on the Base-T Ethernet
interface.
negotiation auto
— enables or disables auto-negotiation on an interface.
flowcontrol
Control how the system responds to and generates 802.3x pause frames on 10G and 40Gig stack units.
Syntax
flowcontrol rx {off | on} tx {off | on} threshold
Parameters
rx on
Enter the keywords
rx on
to process the received flow
control frames on this port. This is the default value for the
receive side.
rx off
Enter the keywords
rx off
to ignore the received flow
control frames on this port.
tx on
Enter the keywords
tx on
to send control frames from this
port to the connected device when a higher rate of traffic is
received. This is the default value on the send side.
tx off
Enter the keywords
tx off
so that flow control frames are
not sent from this port to the connected device when a
higher rate of traffic is received.
Defaults
•
rx off
•
tx off
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The globally assigned 48-bit Multicast address 01-80-C2-00-00-01 is used to send
and receive pause frames. To allow full-duplex flow control, stations implementing
Interfaces
559
