Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
For multicast mode of NLB, to associate an IP address with a multicast MAC
address in the switch, use address resolution protocol (ARP) by entering the
arp
ip-address multicast-mac-address
command in Global configuration
mode. This setting causes the multicast MAC address to be mapped to the cluster
IP address for NLB mode of operation of the switch.
You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when
creating a static ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid.
Related
Commands
clear arp-cache
— clears dynamic ARP entries from the ARP table.
show arp
— displays the ARP table.
arp learn-enable
Enable ARP learning using gratuitous ARP.
Syntax
arp learn-enable
Defaults
Disabled
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
arp retries
Set the number of ARP retries in case the system does not receive an ARP reply in response to an ARP
request.
Syntax
arp retries
number
Parameters
number
Enter the number of retries. The range is from 5 to 20. The
default is
5
.
Defaults
5
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
614
IPv4 Routing