Example (Error
Messages)
Dell#debug ip packet access-group test
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
Dell#00:10:45: %RPM0-P:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is
turned off
Dell#
ip address
Assign a primary and secondary IP address to the interface.
Syntax
ip address
ip-address mask
[secondary]
To delete an IP address from an interface, use the
no ip address [
ip-
address
]
command.
Parameters
ip-address
Enter an IP address in dotted decimal format.
mask
Enter the mask of the IP address in slash prefix format (for
example, /24).
secondary
(OPTIONAL) Enter the keyword
secondary
to designate the
IP address as the secondary address.
Defaults
Not configured.
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You must be in INTERFACE mode before you add an IP address to an interface.
Assign an IP address to an interface prior to entering ROUTER OSPF mode.
ip directed-broadcast
Enables the interface to receive directed broadcast packets.
Syntax
ip directed-broadcast
To disable the interface from receiving directed broadcast packets, use the
no ip
directed-broadcast
command.
IPv4 Routing
623