debug ip bgp ipv6 unicast soft-reconfiguration
Enable soft-reconfiguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [
ipv4-address
|
ipv6-address
|
peer-group-name
]
ipv6 unicast soft-reconfiguration
To disable debugging, use the
no debug ip bgp [
ipv4-address
|
ipv6-
address
|
peer-group-name
] ipv6 unicast soft-reconfiguration
command.
Parameters
ipv4-address
|
ipv6-address
Enter the IP address of the neighbor on which you want to
enable soft-reconfiguration debugging.
peer-group-
name
Enter the name of the peer group on which you want to
enable soft-reconfiguration debugging.
ipv6 unicast
Debug soft reconfiguration for IPv6 unicast routes.
Defaults
Disabled.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv6
unicast routes. If no neighbor is specified, debug is turned on for all neighbors.
Related
Commands
show ip bgp ipv6 unicast dampened-paths
— views BGP dampened routes.
debug ip bgp keepalives
Allows you to view information about BGP keepalive messages.
Syntax
debug ip bgp [
ipv6-address
| peer-group
peer-group-name
]
keepalives [in | out]
To disable debugging, use the
no debug ip bgp [
ip-address
| peer-group
peer-group-name
] keepalives [in | out]
command.
Parameters
ipv6-address
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is /0 to /
128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
716
IPv6 Border Gateway Protocol (IPv6 BGP)