neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP).
Syntax
neighbor {
ipv6-address
|
peer-group-name
} next-hop-self
To return to the default setting, use the
no neighbor {
ipv6-address
|
peer-
group-name
} next-hop-self
command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
(OPTIONAL) Enter the name of the peer group.
Defaults
Disabled.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you configure the
set ipv6 next-hop
command in ROUTE-MAP mode, its
configuration takes precedence over the
neighbor next-hop-self
command.
neighbor peer-group (assigning peers)
Allows you to assign one peer to a existing peer group.
Syntax
neighbor
ipv6-address
peer-group
peer-group-name
To delete a peer from a peer group, use the
no neighbor
ipv6-address
peer-group
peer-group-name
command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group
peer-group-
name
Enter the keywords
peer-group
then the name of a
configured peer group (maximum 16 characters).
Defaults
Not configured.
Command
Modes
ROUTER BGP
IPv6 Border Gateway Protocol (IPv6 BGP)
729
