Usage
Information
Loopback interfaces are up constantly and the BGP session may need one
interface constantly up to stabilize the session. The
neighbor update-source
command is not necessary for directly connected internal BGP sessions.
neighbor weight
Assign a weight to the neighbor connection, which is used to determine the best path.
Syntax
neighbor {
ipv6-address
|
peer-group-name
} weight
weight
To remove a weight value, use the
no neighbor {
ipv6-address
|
peer-
group-name
} weight
weight
command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group to set the timers for all
routers within the peer group.
weight
Enter a number as the weight. The range is from 0 to 65535.
The default is
0
.
Defaults
0
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
In the system best path selection process, the path with the highest weight value is
preferred.
NOTE: To apply the weight to the connection and recompute the best path,
reset the neighbor connection (the
capture bgp-pdu max-buffer-size
*
command).
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network
ipv6-address prefix-length
[route-map
map-name
]
To remove a network, use the
no network
ip-address mask
[route-map
map-name
]
command.
IPv6 Border Gateway Protocol (IPv6 BGP)
739