Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Syntax
neighbor {
ipv6-address
|
peer-group-name
} route-map
map-name
{in | out}
To remove the route map, use the
no neighbor {
ipv6-address
|
peer-
group-name
} route-map
map-name
{in | out}
command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
map-name
Enter the name of an established route map. If the Route
map is not configured, the default is
deny
(to drop all routes).
in
Enter the keyword
in
to filter inbound routes.
out
Enter the keyword
out
to filter outbound routes.
Defaults
Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
IPv6 Border Gateway Protocol (IPv6 BGP)
771
