Command
Modes
EXEC
Command
History
Version 9.5(0.0)
Introduced the support for roles on the MXL 10/40GbE
Switch.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Users entering EXEC Privilege mode or any other configured privilege level can
access configuration commands. To protect against unauthorized access, use the
enable password
command to configure a password for the
enable
command
at a specific privilege level. If no privilege level is specified, the default is privilege
level
15
.
NOTE: If you are authorized for the EXEC privilege mode by your role, you do
not need to enter an enable password.
Related
Commands
enable password
— configures a password for the
enable
command and to
access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optical-info-update interval
seconds
To disable optical power information updates, use the
no enable optical-
info-update interval
command.
Parameters
interval
seconds
Enter the keyword
interval
then the polling interval in
seconds. The range is from 120 to 6000 seconds. The
default is
300 seconds
(5 minutes).
Defaults
Disabled
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1
Replaces the
enable xfp-power-updates
command.
Usage
Information
To enable polling and to configure the polling frequency, use this command.
86
Control and Monitoring
