Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
protocol lldp (Configuration)
— enables LLDP globally.
debug lldp interface
— debugs LLDP.
show lldp neighbors
— displays the LLDP neighbors.
show running-config lldp
— displays the LLDP running configuration.
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
Syntax
advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the
no advertise dot3-tlv {max-frame-
size}
command.
Parameters
max-frame-
size
Enter the keywords
max-frame-size
to advertise the dot3
maximum frame size.
Defaults
none
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
interface
-lldp)
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
advertise management-tlv
Advertise management TLVs (Type, Length, Value).
Syntax
advertise management-tlv {system-capabilities | system-
description | system-name}
To remove advertised management TLVs, use the
no advertise management-
tlv {system-capabilities | system-description | system-name}
command.
866
Link Layer Discovery Protocol (LLDP)