hardware_addr
ess
Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn
format.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor
addresses stored on the control processor (CP).
Syntax
show ipv6 neighbors [
ipv6-address
] [cpu {rp1 [
ipv6-address
] |
rp2 [
ipv6-address
]}] [interface
interface
]
Parameters
ipv6-address
Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
CPU
Enter the keyword
cpu
then either
rp1
or
rp2
(Route
Processor 1 or 2), optionally then an IPv6 address to display
the IPv6 neighbor entries stored on the designated RP.
interface
interface
Enter the keyword
interface
then the interface type and
slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
fastEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then the VLAN ID.
The range is from 1 to 4094.
Defaults
none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
922
Neighbor Discovery Protocol (NDP)
