distribute-list out
To restrict certain routes destined for the local routing table after the SPF calculation, apply a filter.
Syntax
distribute-list
prefix-list-name
out [bgp | connected | isis |
rip | static]
To remove a filter, use the
no distribute-list
prefix-list-name
out
[bgp | connected | isis | rip | static]
command.
Parameters
prefix-list-
name
Enter the name of a configured prefix list.
bgp
(OPTIONAL) Enter the keyword
bgp
to specify that BGP
routes are distributed.
connected
(OPTIONAL) Enter the keyword
connected
to specify that
connected routes are distributed.
isis
(OPTIONAL) Enter the keyword
isis
to specify that IS-IS
routes are distributed.
rip
(OPTIONAL) Enter the keyword
rip
to specify that RIP
routes are distributed.
static
(OPTIONAL) Enter the keyword
static
to specify that only
manually configured routes are distributed.
Defaults
Not configured.
Command
Modes
ROUTER OSPF
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The
distribute-list out
command applies to routes autonomous system
boundary routers (ASBRs) redistributes into OSPF. It can be applied to external type
2 and external type 1 routes, but not to intra-area and inter-area routes.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route
computation so that convergence takes less time.
Syntax
fast-convergence {
number
}
To cancel fast-convergence, use the
no fast convergence
command.
Parameters
number
Enter the convergence level desired. The higher this
parameter is set, the faster OSPF converge takes place. The
range is from 1 to 4.
Open Shortest Path First (OSPFv2 and OSPFv3)
935