• For Loopback interfaces, enter the keyword
loopback
then a number from zero (0) to 16383.
• For a Port Channel, enter the keywords
port-channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For VLAN interface, enter the keyword
vlan
then a
number from 1 to 4094.
Defaults
The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
telnet
— telnets to another device.
ip tftp source-interface
Assign an interface’s IP address in outgoing packets for TFTP traffic.
Syntax
ip tftp source-interface
interface
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For Loopback interfaces, enter the keyword
loopback
then a number from zero (0) to 16383.
• For a Port Channel, enter the keywords
port-channel
then a number. The range is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For VLAN interface, enter the keyword
vlan
then a
number from 1 to 4094.
Defaults
The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command
Modes
CONFIGURATION
94
Control and Monitoring