you enable authentication on an area with the
area authentication
command,
you do not enable encryption at the same time.
If you have enabled IPsec authentication in an OSPFv3 area with the
area
authentication
command, you cannot use the
area encryption
command in
the area at the same time.
The configuration of IPsec encryption on an interface-level takes precedence over
an area-level configuration. If you remove an interface configuration, an area
encryption policy that has been configured is applied to the interface.
clear ipv6 ospf process
Reset an OSPFv3 router process without removing or re-configuring the process.
Syntax
clear ipv6 ospf process
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
debug ipv6 ospf bfd
Display debug information and interface types for BFD on OSPF IPv6 packets.
Syntax
[no] debug ipv6 ospf bfd [
interface
]
To cancel the debug command, use the
no debug ipv6 ospf
command.
Parameters
interface
(OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a tunnel interface, enter the keyword
tunnel
then a
number. The range is from 1 to 16383.
984
Open Shortest Path First (OSPFv2 and OSPFv3)
