Getting Started Guide
15
Performing the N2128PX-ON Initial Configuration
The initial configuration procedure is based on the following assumptions:
•
The Dell Networking switch was never configured before.
•
The Dell Networking switch booted successfully.
•
The console connection was established, and the
Dell Easy Setup Wizard
prompt appears on the screen of a VT100 terminal or terminal equivalent.
The initial switch configuration is performed through the console port. After
the initial configuration, you can manage the switch from the already-
connected console port or remotely through an interface defined during the
initial configuration.
NOTE:
The switch is not configured with a default user name, password, or IP
address.
Before setting up the initial configuration of the switch, obtain the following
information from your network administrator:
•
The IP address to be assigned to the management interface.
•
The IP subnet mask for the network.
•
The IP address of the management interface default gateway.
These settings are necessary to allow the remote management of the switch
through Telnet (Telnet client) or HTTP (Web browser).
Enabling Remote Management
On the N2128PX-ON/N3132PX-ON switches, you can use any of the switch
ports on the front panel for in-band management. By default, all in-band
ports are members of VLAN 1.
The
Dell Easy Setup Wizard
includes prompts to configure network
information for the VLAN 1 interface on the N2128PX-ON switch. You can
assign a static IP address and subnet mask or enable DHCP and allow a
network DHCP server to assign the information.
Refer to the
CLI Reference Guide
for commands to configure network
information.
Summary of Contents for N2128PX-ON
