40
Getting Started Guide
Example Session
This section describes a
Dell Easy Setup Wizard
session. The following
values are used by the example session:
•
The SNMP community string to be used is
public
.
•
The network management system (NMS) IP address is
10.1.2.100
.
•
The user name is
admin
, and the password is
admin123
.
•
The OOB management interface uses
DHCP
for IP address assignment.
•
The IP address for the VLAN 1 routing interface is
10.1.1.200
with a
subnet mask of
255.255.255.0
.
•
The default gateway is
10.1.1.1.
The setup wizard configures the initial values as defined above. After
completing the wizard, the switch is configured as follows:
•
SNMPv2 is enabled and the community string is set up as defined above.
SNMPv3 is disabled by default.
•
The admin user account is set up as defined.
•
A network management system is configured. From the management
station, you can access the SNMP, HTTP, and CLI interfaces.
•
DHCP is enabled on the OOB management interface.
•
An IP address is configured for the VLAN 1 routing interface.
•
A default gateway address is configured.
NOTE:
In the following example, the possible user options or default values are
enclosed in [ ]. If you press <Enter> with no options defined, the default value is
accepted. Help text is in parentheses.
Summary of Contents for N2128PX-ON
