58
Guide de mise en route
Installation de N2128PX-ON
Montage en rack d’un commutateur N2128PX-ON
AVERTISSEMENT:
Prenez connaissance des consignes de sécurité exposées
dans les
Informations relatives à la réglementation et la sécurité
ainsi que des
informations relatives à la sécurité des autres commutateurs qui se connectent
au commutateur ou qui le prennent en charge.
Le connecteur d’alimentation CA se trouve sur le panneau arrière du commutateur.
Installation dans un rack
AVERTISSEMENT:
N’utilisez pas les kits de montage en rack pour suspendre
le commutateur en dessous d’une table ou d’un bureau ou pour le fixer à un mur.
PRÉCAUTION:
Avant de poursuivre, débranchez tous les câbles du commutateur.
Si nécessaire, retirez tous les coussinets auto-adhésifs du dessous du commutateur.
PRÉCAUTION:
Pour monter plusieurs commutateurs dans un rack, montez les
commutateurs de bas en haut.
1
Placez le support de montage qui vous est fourni sur un côté du
commutateur en faisant en sorte que les orifices de montage sur le
commutateur s’alignent sur ceux du support de montage. La Figure 1-1
montre où monter les supports.
Figure 1-1. Fixation des supports
2
Insérez les boulons fournis dans les orifices de montage et vissez-les avec
un tournevis.
Summary of Contents for N2128PX-ON
