3. securing tabs
3.
Install a new system battery by holding the battery with the "+" sign facing up and slide it under the
securing tabs.
4.
Press the battery into the connector until it snaps into place.
Figure 34. Installing the system battery
1.
positive side of the battery connector
2. battery connector
Next steps
1.
Install the expansion card riser.
2.
Follow the procedure listed in the After working in your system section. .
3.
While booting, press F2 to enter System Setup and ensure that the battery is operating properly.
4.
Enter the correct time and date in the System Setup
Time
and
Date
fields.
5.
Exit System Setup.
Related Links
Safety instructions
Before working inside your system
After working inside your system
Hard drive backplane
Dell Storage NX430 NAS supports four 3.5-inch SAS/SATA backplane.
Removing the hard drive backplane
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
CAUTION: To prevent damage to the drives and backplane, you must remove the hard drives
from the system before removing the backplane.
CAUTION: You must note the number of each hard drive and temporarily label them before
removal so that you can insert them in the same locations.
108
