After working inside your system
Prerequisites
Follow the safety guidelines listed in the Safety instructions section.
Steps
1.
Install the system cover.
2.
If applicable, install the system into the rack.
For more information, see the
Rack Installation
placemat at
Dell.com/storagemanuals
.
3.
If removed, install the optional front bezel.
4.
Reconnect the peripherals and connect the system to the electrical outlet.
5.
Turn on the system, including any attached peripherals.
Recommended tools
You need the following tools to perform the removal and installation procedures:
• Key to the bezel lock. This is needed only if your system includes a bezel.
• Phillips #2 screwdriver
• Plastic scribe
• Wrist grounding strap
Front bezel (optional)
The front bezel is attached to the front side of the server and prevents accidents while removing the hard
drive or when pressing the reset or power button. The front bezel can also be locked for additional
security.
Installing the optional front bezel
Prerequisites
1.
Follow the safety guidelines listed in the Safety instructions section.
Steps
1.
Locate and remove the bezel key.
NOTE: The bezel key is attached to the back of the bezel.
2.
Hook the right end of the bezel onto the chassis.
3.
Fit the free end of the bezel onto the system.
4.
Lock the bezel by using the key.
55
